Installation Guide

a
a
Figure 1
Figure 2
W
1. Measure the distance between the two finished walls. This
distance is marked as W.
b
See Figure 1 for details
S
See Figure 2 for details
Figure 3
W
W
a
2. Your Upper Guide Rail (1) and Bottom Track (10) have been
precut for your shower model opening width: 48” or 60”.
If W-width of your wall-to-wall opening is equal to the size of your
shower model, it is unnecessary to cut the upper guide rail and
bottom track and you can continue to Step 3.
If W-width of your wall-to-wall opening is less than the size of your
shower model, you will need to cut the Upper Guide Rail from the
end and cut the bottom track from the two end at equal length.
The length to cut off will be L:
L=Subtract W from the size of your shower model.as W.
FOR EXAMPLE
If your wall opening W=47". Your shower model is 48".
L=48"-47"=1"
You have to cut 1" off from the rail
You have to cut ½" off from two ends of the bottom track
3. Disassembled the Guide Block (11) from the Bottom Track (10)
with Philips screw driver.
Remark: the Wool Tops (9) has been pre-installed to the Bottom
Track.
Place the Bottom Track onto the shower tray or shower base and
level it.
See Figure 3 for details