Installation Guide

c. d.

22. Install the Anti-Splash Threshold

Pull out the Cover in the guide block (12), put the Anti-Splash Threshold (8) to the slot of the Guide Block, in front of the

Glass Door (6) on the shower tray or threshold. Put the Threshold Cover (11) to the end of the Threshold against the Small

Stationary Glass (21). Mark a drill hole on the shower base with a pencil. Drill the hole in the shower base with drill bit

8mm (5/16"). Attach the threshold and mark a drill hole on a shower base. Drill a hole in the shower base (refer to figure

d. for drill bit size). Apply silicone into the holes, insert the Wall Anchors (13). Apply the silicone along the bottom of the

Anti-Splash Threshold and the slot on the Guide Block. Now put the Anti-Splash Threshold and the cover back to its

position, now secure the Cover to the shower tray or threshold with M4x45 screws (9).

Please see Fig 22 ( a to i)

www.lesscare.com

ULTRA-C

SHOWER DOORS

INSTALLATION STEPS

Outside