Installation Guide

Figure 11
b.
c.
a.
d.
e.
f.
g.
h.
11. The slot direction for the Stationary Glass (16) of the Guide Block (13) can be adjusted. Loosen the screw on the bottom of
the Guide Block and adjust the direction. Put the Guide Block to the Stationary Glass, make sure that the glass is inside the slot
of the Guide Block. Now mark down the predrilled hole of the Guide Block with pencil. Drill the hole with drill bit 8mm(5/16")
on the shower tray or threshold. Apply silicone into the holes, insert the Wall Anchors (14), now secure the Guide Block to the
shower tray or threshold with M5x30 screws (12).
Please see Fig 11 for details
www.lesscare.com
ULTRA-C
TUB DOORS • SHOWER DOORS
INSTALLATION STEPS
16
inside
inside
inside
inside
inside
inside
inside
Silicone
13
13
13
14
12
16