Installation Guide

Figure 16
15. Slide the Side Anti-Aater Atrip (13) & (19) to the Stationary Glass (12) & (17), remove the flapper that interfere with the
Upper Guide Rail (2) with scissors.
See Figure 16 for details.
NOTE: You can cut the strips to size by using a knife if necessary, do not cut anti-water strips while they are installed on the
glass. You must take off the anti-water strip cut them as needed and re-install them. Normally, the strips are pre-cut to the
size of the glass door.
www.lesscare.com
ULTRA-D
SHOWER DOORS
INSTALLATION STEPS
22
13
9
a.
b.
c.
d.
Outside
Outside
Outside
Outside