Installation Guide

www.lesscare.com
ULTRA-E
SHOWER DOORS
INSTALLATION STEPS
7
a.
b.
2.Remove the corner pads from the Glass door (4).Cut the Side strip (2) according to the measurements. Slide the
side anti-water Strip (2) to the Glass Door (4).
See Figure 2 for details.
3. Place a piece of flat timber (3/8” thick) on the threshold or
the shower base. Place the Glass door(4) on the flat timber.
Carefully butt up the door with hinged side against the
wall, adjust its position and level it vertically and horizontally.
ATTENTION:
Please check with a level and be sure that the door is
absolutely plumb.
See Figure 3 for details.
Figure 2
Figure 3
4
2
4
2