Installation Guide

www.lesscare.com
ULTRA-G
SHOWER DOORS • SHOWER ENCLOSURES
10
INSTALLATION STEPS
Open Glass Door (17) by approximately 90º then push the Side Anti-water Strip (3) into the vertical slot of the Glass Profile For
Glass Door (2). Install the Bottom Anti-water Strip (8) onto the bottom of the Glass Door (17). Place the Anti-water Strip (6) to
the long side of the Glass Door (17)
NOTE: You can cut the strips to size by using a knife if necessary, do not cut ant-water strips while they are installed on the
glass. You must take off the anti-water strip cut them as needed and re-install them. Normally, the strips are pre-cut to the size
of the glass door.
See Figure 10 for details
6. PVC strips Installation
a
d
b
e
f
c
g
Figure 10
3
3
8
8
8
6
6
8
Outside
(bathroom)
TOP VIEW
Inside
(shower)
Outside
(bathroom)
Inside
(shower)
Outside
(bathroom)
Inside
(shower)