Installation Guide

www.lesscare.com
ULTRA-G
SHOWER DOORS • SHOWER ENCLOSURES
14
9. Shower Enclosure/Stationary Panel Assembly and Installation
Stationary Panel Assembly and Installation
NOTE: Use parts from Diagram B on page 4 for Shower Enclosure/Stationary Panel
assembly and installation.
Figure 15
9.1 Insert Stationary glass panel with profile (20) into Wall profile for
stationary glass panel (19). Position the assembly of (20 and 19) against the
wall (do not screw or drill anything at this step).
See Figure 15 for details.
IMPORTANT: Stationary glass panel with profile (20) has been factory
pre-assembled. Do not try to detach the stationary glass panel from the
aluminum profile.
9.2 Level the assembly of Wall profile for stationary glass panel (19)
and Stationary glass panel with profile (20) with already installed
Shower door (17). Now, level Stationary glass panel with profile (20)
to Shower door (17).
17
20
19
20
19
17
20
17
20
17
INSTALLATION STEPS
20
19
Figure 16
Drill bit
Ø 5/16"
b
c
d
20
19
19
Once, all are leveled and lined-up draw a
line along the inner and outer sides of Wall
profile for stationary glass panel (19).
Detach Stationary glass panel with profile
(20) from Wall profile for stationary glass
panel (19). Place the Wall profile for
stationary glass panel (19) to the outlined
position and mark down 3 drilling holes
through the pre-drilled holes in the Wall
profile for stationary glass panel (19)
using pencil or marker. Now, drill the holes
using ø 5/16" drill bit in the wall.
See Figure 16 for details.