Installation Guide

www.lesscare.com
ULTRA-G
SHOWER DOORS • SHOWER ENCLOSURES
17
Figure 20
10. Secure the Stationary Glass Panel with Wall Profile and Shower Base Threshold
INSTALLATION STEPS
a
b
c
25
25
25
27
27
26
Inside
(shower)
outside
(bathroom)
6"
20" 20" 20" 6"
10.1 After leveling Stationary glass panel with profile (20) with the Glass door (17) mark all screwing points in the middle of
overlap between Stationary glass panel with profile (20) and Wall Profile for stationary panel (19). Secure Wall Profile for
stationary panel (19) and Stationary glass panel with profile (20) together by Inserting 4 self screwing Round head screws
M3.5x13 (26) through Washer for screw (25) and screw them in through Stationary glass panel with profile (20) and Wall
Profile for stationary panel (19) using electric powered screwdriver (do not drill holes for screws). Cover the exposed screw
heads with Screw Decorative Cover (27).
See Figure 20 for details
IMPORTANT: Be sure not to screw Round
head screws M3.5x13 (26) through the
glass itself (always double check!)
NOTE: In case if you over-tighten any of
Round head screws M3.5x13 (26) while
securing Stationary glass panel with
profile (20) and Wall Profile for stationary
panel (19). Find and Mark another location
slightly upper or lower away from the
screwed hole and screw in Round head
screw M3.5x13 (26). Apply a small amount
of silicone into wrongly screwed hole.
IMPORTANT: If installation of
the stationary panel requires
out-of-plumb adjustability,
find the middle of overlap
between Stationary glass
panel with profile (20) and
Wall Profile for stationary
panel (19) and mark all
screwing points with a pencil
or marker.
1" MAX
Out-of-Plumb Adjustability