Installation Guide

www.lesscare.com
ULTRA-G
SHOWER DOORS • SHOWER ENCLOSURES
18
11.1 Align center of the hole on Stationary glass
panel with profile (20) with the the wall. Mark a dot
using pencil or marker on the wall. From the marked
dot level, measure, and mark 2" and 6" dots from Wall
profile for stationary glass panel (19) for hole drilling
while level is still in place. Repeat the step for lower
shelf.
11.2 Drill the marked holes using ø5/16" drill bit.
Apply silicone into the holes and insert 8mm (5/16")
wall anchors (30) into the holes. Repeat the step for
lower shelf.
11.3 Attach Shelf brackets for Wall (22) to the wall
using the Round head screw M4X60 (21) and attach
the Shelf brackets for stationary glass panel (23) to
Stationary glass panel with profile (20). Insert each
Glass shelf (24) into the shelf brackets and fasten the
screws at the bottom of all brackets. Repeat the step
for lower shelf.
See Figure 21 for details.
11. Glass Shelves Installation
Figure 21
Figure 22
21
22
22
2"
6"
Wall Wall
Wall
Wall
Wall Wall
22
Drill Bit
Ø=5/16"
a b
c
d
e f
INSTALLATION STEPS
WALL
TOP VIEW TOP VIEW
WALL
23
23
IMPORTANT: Make sure that Clear Rubber
Gaskets are in between the Stationary glass
panel with profile (20) and Shelf Bracket Cap
for Stationary glass Panel; between Shelf
brackets for stationary glass panel (23) and
Stationary glass panel with profile (20). Then,
tighten Shelf Bracket Cap for Stationary glass
Panel by hand only. Do not use any types of
tools to tighten it.
See Figure 22 for details
20
20
24
23
22
24
22
Rubber Gaskets
Shelf Bracket Cap
for Stationary
glass Panel