Installation Guide

12. Place the Guide Block (13) on the shower base or shower tray and parallel it to the Fixed Glass (11). It should not pass beyond
the vertical edge of the Fixed Glass. Take a measurement to ensure the distance between the front line of the glass and the center
line of the Guide block is 1 3/16". Hold the guide block firmly and mark down the drilling hole on the shower base or shower tray.
Remove the Guide block, now drill the hole using Ø 5/16" drill bit, insert the Wall Anchor (22) in and then fasten the Guide block
to the shower base or shower tray with the Countersunk Screw M5X30 (18).
See Figure 13 for details.
Figure 13
a
b
c
d
www.lesscare.com
ULTRA-B
TUB DOORS • SHOWER DOORS
INSTALLATION STEPS
1"
18