Installation Guide

14. Install the Rollers (4) to the Glass Door (7), place Anti-Water Strip (12) and Bumper Strip (1) into the glass door as well.
Remember to remove the flapper that interferes with the Guide Rail (10)
NOTE: You can cut the strips to size by using a knife if necessary, do not cut anti-water strips while they are installed on the
glass. You must take off the anti-water strip cut them as needed and re-install them. Normally, the strips are pre-cut to the
size of the glass door.
See Figure 15 for details.
IMPORTANT: Make sure that clear rubber Gaskets are in between the Glass Door. Then, fasten Screws tightly. Make sure
parts are in the right position. Do not let any metal parts come into contact directly with glass,which will damage the glass
notches and cause scratches or damage to the glass .If ignored, could result in serious injury or death.
Figure 15
c d
b
a
www.lesscare.com
ULTRA-B
TUB DOORS • SHOWER DOORS
INSTALLATION STEPS
7
4
4
4
7
12B
12B
1
4
7
7
20