Installation Guide

EXTREMELY IMPORTANT TECHNICAL MAINTENANCE STEP!
www.lesscare.com
25
ULTRA-B
TUB DOORS • SHOWER DOORS
EXTREMELY IMPORTANT INSTALLATION & TECHNICAL MAINTENANCE INSTRUCTIONS
1. To avoid the Glass Door hitting a wall during opening and closing, make sure that the
distance between the Glass Stoppers and the wall is not less than 6" for Stationary Glass
Panel and 4" for Glass Door. (See Figure 1)
2. Glass Stoppers has to be installed very tight to the Upper Guide Rail and must not move.
Double check if all screws on the Glass Stoppers are tight. Tighten the screws if necessary.
(See Figure 2)
3. Make sure that the distance between the Safety Pin and the Upper Guide Rail is not over
1/24” (1.0 mm). The distance between the Safety Pin that is set right under the Upper Guide
Rail must be as short as possible. The shortest distance will ensure that the Glass Door will
not shake in the Guide Block during opening and closing. (See Figure 3)
4. The A-Shape Anti-Water Strip and Side Anti-Water strip must be 1-2 mm longer than the
Glass Door to make sure that the glass corner will not contact the wall directly.(See Figure 4)
5. Double check front and back surfaces, all sides, and all corners of the Glass Door and Sta-
tionary Glass Panel to make sure that the glass parts are in perfect condition without any
scratches, and/or dents. If any type of breakage and/or other imperfection is found do not
install the affected glass part.
A licensed and professional contractor has to comply with the required specifications and dimensions
illustrated on this diagram during installation and technical maintenance of the product.
After installation use the shower door for approximately 2-3 weeks or 20-25 times (whichever
comes first). After that be sure to re-inspect all screws, make sure they are tight and tighten them
if necessery. Repeat the adjustments if necessary.
By installing and operating this product the installer and the owner of the product acknowlage,
understand, and agree to follow all of the installation and technical mainatance procedures and/or
policies described in this installation instructions manual including this page. If you do not under-
stand or agree to any or all of these instructions or policies do not install or operate the product.
Failure to follow and/or comply with any or all of the instructions and policies will void any warranty
of the product and will automatically removes any and all liability from manufacturer and/or distribu-
tors of the product.
EXTREMELY IMPORTANT INSTALLATION
& TECHNICAL MAINTANCE INSTRUCTIONS!