Installation Guide

www.lesscare.com
ULTRA-H
TUB DOORS • SHOWER DOORS
INSTALLATION STEPS
Figure 1
a.
b.
c.
d.
5
1.Use a tape measure to get the location of the
Guide Rail Holder(2). The height should be 76”
(shower door) or 62'' (tub door) from the shower
base or bathtub to the top of the Rail Holder.
2. Once the Guide Rail Holder(2) location is fixed,
mark down the 2 predrilled holes on the wall, using
a pencil or marker, to prepare for drilling. Noted
that the Rail holder should be placed with the two
smaller screws facing inside the shower. Now, drill 2
holes in the wall using 8mm (5/16") Drill Bit. Insert
the 2 Wall Anchors(12) and hammer them in.
Secure the Top Guide Rail Holder to the wall by
using 2 M5x60mm Countersunk Self-Tapping
Screws(11).
See Figure 1 for details.
Note: the Guide Rail Holder should be installed with
the two smaller screw facing inside the shower.
NOTE: The other Guide Rail Holder
should be installed in the same way
above
2
12
11
2