Installation Guide

www.lesscare.com
SHOWER BASE TRAYS
PREPARATION FOR INSTALLATION
2
PREPARATION FOR INSTALLATION
TOOLS & MATERIALS REQUIRED:
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN SERIOUS INJURY OR DEATH
CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT.
THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION!
LICENSED AND INSURED PLUMBER CONTRACTOR IS REQUIRED TO INSTALL
THIS PRODUCT INCLUDING ASSISTANCE OF A SECOND PERSON DURING INSTALLATION
2 PEOPLE ARE REQUIRED TO LIFT AND CARRY
THIS PRODUCT DURING INSTALLATION
LessCare reserves the right to change, update, modify, alter, redesign this manual/product or its policies without prior notice!
It is your responsibility to visit website to download or contact customer service for the most updated version of the installation instructions.
No modifications to the product are allowed. Modifications of any types to the product will result in serious injuries or may cause death.
LessCare shall not be liable for any injuries or property damages in connection with this product during installation or use of this product!
IMPORTANT UNPACKING INSTRUCTIONS:
When you have open top carton box lid, do not take out the product before you read this and have the product in place. Have a soft cloth blanket
min ¼" thick and make sure cloth blanket is bigger then the size of the product in your working area place. Set this soft cloth blanket on the floor of
working area. Take out the product from the carton box and set it on the soft cloth blanket. Do not lean it on the wall or floor without the soft cloth
blanket.
ATTENTION! Never set the product on floor, tile, solid floor, or wall surface without a soft cloth blanket. If you set it without soft cloth blanket it
will cause scratches to the surface. Improper handling may cause scratches as well. NEVER set the product on its corners. Make sure the your
floor is leveled with the soft cloth blanket when preparing the product for installation.
After opening the package, read this introduction carefully. Check that all of the needed parts are included in the package by checking all the
components on the diagram of components. Examine boxes and packages for shipping damage. If the unit has been damaged or missing parts,
please contact our customer support department immediately. Please note that LessCare will not replace any damaged products or missing parts
after 2 business days of the order receipt.
VERY IMPORTANT! You should consult your local building codes with questions on installation compliance standards. Building and plumbing
codes may vary from state to state and location. LessCare is not responsible for code compliance standards for your project and will not accept
any returns. Prior to installation, ensure that the installation surface is leveled and solid, and will be able to support the total weight of the unit.
READ CAREFULLY THIS GUIDE BEFORE PROCEEDING WITH THE INSTALLATION.
The shower base feet are not trimmed to be level, and are intended to be set in mortar. Construct a leveled subfloor that will adequately support
the shower base. Do not support the shower base by the rim. Shower base tray model with centered drain is shown for illustrative purpose, The
same installation steps apply for right and left drain models.
• Make sure you have all the tools and materials needed for installation. Always wear safety glasses at all times during the installation
• The shower base must be installed perfectly leveled on a floor and walls that are also perfectly leveled
• The weight of the shower base must rest on the floor. No weight should be supported by the tiling flange or the base skirt
OTHER TOOLS & MATERIALS MAY BE REQUIRED
Drill
Soft Cloth
or Blanket
Waterproof
Silicone
Tape
Measure
Pencil/Marker Safety Glass Mortar
Screws
LevelKnife Caulk Gun
Soft Wood
Shim
IMPORTANT: All required drainage and plumbing must be installed prior the shower base tray installation. All provided in the
installation manual are for reference only. The actual shower base tray including overall dimensions and drain location must be
measured before installation. Dimensions to the center of drain location may have a tolerance +/- 1/2".