Owner and manual

www.lesscare.com
LT2T
ONE PIECE TOILET
CLEANING & TROUBLESHOOTING (FILL VALVE)
9
FILL VALVE CLEANING
inlet pipe
filter
shut off
water supply
brush
(Filter which is located inside the inlet valve shank is require for cleaning periodically)
1
2
3
4
5
Shut off the water supply
valve (angle stop) then
reomove the water supply
line from the adaptor.
Insert the water supply
back to the inlet valve shank
and turn on the water supply
valve/angle stop.
Remove the filter sreen
from the inner portion
of the shank
Clean the filter screen
with water
Re-install clean filter
back into the inner
portion of the shank.
Water level is too high or
too low
Improper water level
adjustment
Adjust the water level
Fill valve fails to shut off
or fails to fill the water
into the toilet's tank
1. Inlet valve switch is
turned on.
2. Inlet valve float crashed
against ceramic wall
3. Filter screen is clogged
due to dirty water
4. Improper refill hose
installation
1. Turn on inlet valve switch
2. Adjust inlet valve position
3. Clean the filter screen
4. Install refill hose correctly (see
diagram on the right)
TROUBLESHOOTING
Issue Cause Solution Solution #4
RIGHTWRONG
Water
Level
Use soft sponges or soft-cloths to clean the surface. Always rinse thoroughly any cleaning solutions immediately after cleaning. Do
not any chemical remain on the surface for extended periods of time.
Do not pour any mounts of chlorine or any other chemicals into the tank. Use of chemical products will result in damage to the fill valve and
flush valve components and may cause flood and property damage
Note: fill and flush valves are maintenance free. No maintenance is required.
FILL/FLUSH VALVES MAINTENANCE & CARE
MAINTENANCE & CARE
Retain these installation instructions for future reference!
Thank you for using LessCare products!
IMPORTANT!
DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and simmilar solutions. Use of such solutions may cause
corrosion, finish peeling, and/or dull the surface.
DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface.