Owner and manual

www.lesscare.com
TECHNICAL DATA
• Single flush 1.6GPF
12"
5 1/2"
5 1/2"
3"
Rough-in
Standard
5 1/2"
4 1/2"
10"
Side View Back View
Floor
Single
Flush
(1.6GPF)
12"
5 1/2"
Rough-in
Standard
Floor
5 1/2"
Side View
SIngle
Flush
(1.6GPF)
LT2T
3
You may connect the water supply line using two different
options. In both options distance from the floor to the
center of the supply line must be 5 1/2". In Supply Position
1, the water supply is located behind the toilet and is
offset by 4 1/2" from the installed toilet's center. In supply
Position 2 the water supply line must offset by 10" from
the center of the installed toilet.
Flush GPF amount is factory
set. No additional adjustment
is required.
Adjust the water level in the
toilet's tank if neccessary by
rotating the adjustment
screw to increase (+) or
decrease (-) a level of water
in the toilet's tank.
ATTENTION! Dimensions may vary by up to 3/8". It is highly recommended to pull
all dimensions of actual model for installation and measuring purposes.
WATER SUPPLY LOCATION & TECHNICAL INFORMATION
ONE PIECE TOILET
Threaded
Shunk (Water
Supply Fill Valve)
Supply
Position 2
Wall
Wall
Tank Top View (Inside)
Lid Top View (Outside)
Supply
Position 1