Owner and manual

ONE PIECE TOILET
ADJUSTMENT & MAINTENANCE (SINGLE VALVE)
Remove body of the valve
BASE INSTALLATION
metal anchor
Installation of the valve body
PUSH BUTTON INSTLLATION
Remove nut
Installation of push button on tank lid
Tighten the nut
push plate
nut
rod
REFILL TUBE INSTALLATION
Refill tube
water level
FLUSH VOLUME ADJUSTMENT
Float up,the flush volume decreases.
Float down,the flush volume increases.
Float
Push down the buckle
(optional to adjust float)
TROUBLESHOOTING
water level
water level
Rod to push button is too long
The valve and base do not fit properly
Please remove and then reassemble.
Push button rods too short,readjust length
Body
push plate
rubber cap
locknut
rod
1.Leaking
www.lesscare.com
7
LT2T
Important Note: Flush GPF amount is factory set. No additional adjustment is required.
This page is for reference only. All adjustments are already made by manufacturer.
Place one end of the
metal anchor into the
ceramic hole and then
the other end.
Use a screwdriver to
tighten the valve
sufficiently to avoid
leakage.
Adjust valve clockwise or
counterclockwise to insure rod
aligns and falls on push plate
If the rod is too short or long,move
the rod by turning it up or down to
obtain suitable position then tighten
it with the adjusting nut.
Refill tube should be
positioned higher than
water level
Error if lower
than water level
The refill tube wasn't
installed propernly
Cutasmall portion
then readjust Note: cut -
the upper end of the rod
Debris in water is affecting the valve
Remove,clean and reassemble.
Adjust refill tube,make sure tube
is above the water line
Rubber gasket does not
properly fit.Adjust gasket so
the flat end is seated flush
with the ceramic.
2.Little or no flush volume when the
push button is activated