Installation Instructions

This device complies with Part 15 of the FCC rules.
Operation is subject to the
following two conditions: 1) this device may not
cause harmful interference, and 2)
this device must accept any interference received,
including interference that may
cause undesired operation.
Note: This equipment has been tested and found to
comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful
interference to radio communications. However, there is
no guarantee that
interference will not occur in particular installation.
If this equipment does cause
harmful interference to radio or television reception,
which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different
from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority
to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits
set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Statement:
22