User Manual
2. SENSING ANGLE AND DISTANCE TEST
To test whether the camera can effectively monitor the area you
choose, this test is recommended to check the sensing angle and
monitoring the distance of the camera. To perform the test:
Switch the camera to the SETUP mode.
Make movements in front of the camera at several positions within
the area where you expect the game or subjects to be. Try different
distances and angles from the camera.
If the motion indicator LED light (BLUE light) blinks, it indicates that
position can be sensed and the camera works.
The results of your testing will help you find the best placement when
mounting and aiming the camera. The height away from the ground for
placing the device should vary with the animal size appropriately. In
general, 3 to 6 feet is preferred.
You can avoid potential false triggers due to temperature and motion
disturbances in front of the camera by not aiming it at a heat source or
nearby tree branches or brush (especially on windy days).
Note:
DO NOT install the camera behind the glass window as that is not
possible to sense any motion.
3. SWITCHING ON THE CAMERA
Once you switch to the ON mode, the motion indicator LED (red) will
blink for about 15 seconds. After it stops blinking, the PIR is active, and
any motion that is detected by it will trigger the capture of photos or
videos as programmed in the SETUP Menu. Please note, the PIR is
strongly sensitive to ambient temperature. The greater the temperature
difference between the environment and your subject, the farther the
possible sensing distance. The average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the following:
sufficient?
- 14 -