User Manual
2). Night photos or videos appear too bright
flash range, no closer than 10 ft. (3 m) from the camera. Subjects
may appear too bright at closer distances.
3). Daytime photos or videos appear too bright
sources during the day.
4). Photos with streaked subject
subjects, the 8MP or 12MP or 16MP resolution settings may not
perform as well as the 3MP setting.
streaks on the photo, try the 3MP setting instead.
5). Red, green or blue color cast
Under certain lighting conditions, the sensor can become
confused resulting in poor color images.
If this is seen on a consistent basis, then the sensor may need
servicing. Please contact our customer service.
6). Short video clips—not recording to the length set
Check to make sure that the SD card is not full.
Make sure that the camera has good batteries in it. Near the end
of the battery life, the camera may record shorter video clips to
conserve power.
4. Camera won't retain settings.
Make sure that you have been saving the changes to any parameter
settings that you made while in SETUP mode by pressing the "OK"
key after changing the setting. If you don't save your new setting
after changing it, the camera will continue to use the original default
setting for that parameter.
5. SD card is hard to install.
Please try the following step to install the memory card:
1) Insert the SD card into the card slot with its label side upwards. A
"click" sound indicates that the card is installed successfully. If the
SD card is not installed correctly, the device will not display an
SD card icon on the LCD in SETUP mode.
- 18 -