Network Attached Storage User's Manual FNS-5000, FNS-7000, GNS-8000

• Deny Access

Denies all files access on the network share.

System Tools

The following system tools allow optimized maintenance or management of your LevelOne

NAS:

• SNMP Settings

In order to use Simple Network Management Protocol (SNMP) to manage the LevelOne

NAS's network components, the SNMP service must be started.

• Alert Notification

Configures administrator’s e-mail address and SMTP server IP address. In case of

warning or malfunction, an email is automatically sent to the administrator.

• Restart / Shutdown

Powers off or restarts the LevelOne NAS.

• Hardware Settings

You can enable or disable the following hardware functions of your LevelOne NAS:

1. Enable LCD panel setting function

The default is enabled. Allow you to change the TCP/IP configuration using the

LCD panel buttons.

2. Enable configuration reset switch

The default is enabled. Depress and hold on the configuration reset switch for 5

seconds to reset the administrator password and network settings to the factory

default.

3. Enable hard disk standby mode

The default is enabled. Hard disk will go to standby mode if there is no access within

the period you specify.

4. Enable buzzer

Default setting is enabled. If the buzzer is disabled, it will not sound when a system

error occurs, but the warning light will still shine.

• UPS (For GNS-8000 Only)

The LevelOne NAS is equipped with a serial port interface to support UPS

(uninterrupted power supply) connection. By connecting the UPS to the serial port

and enabling the UPS support, you can protect the system from abnormal shutdown

caused by power outage. In the event of utility power failure, the system will shut

down automatically by probing the power status of the connected UPS unit. You can

also set a shutdown timer to power off the system automatically after it detects the

AC power failure. In general, the UPS can keep supplying the power for the system

for about 5 to 10 minutes. But this depends on the maximum load of the UPS and the

number of the loads connected to it.

If the UPS you used is not supported, please contact technical support or visit our

web site for updated news.

• System Update

Performs system software updates. Make sure that the image file that you are about to