User guide

7
LED Indicators
LED State Indication
On (Green) The Print Server’s power is on.
Power
Off The Print Server’s power is off.
Status
Blinking for POST
(Red)
When power switched on, the Status indicator will flash four
times, and then off.
100Mbps On (Green) LAN Port has a valid network connection at 100Mbps.
10Mbps On (Orange) LAN Port has a valid network connection at 10Mbps.
Parallel Blinking (Green) Data is being transmitted via Parallel Port.
Blinking (Green) Data is being transmitted via USB Port at USB 2.0.
USB1
Blinking (Orange) Data is being transmitted via USB Port at USB 1.1.
Blinking (Green) Data is being transmitted via USB Port at USB 2.0.
USB2
Blinking (Orange) Data is being transmitted via USB Port at USB 1.1.
Before you start, you should prepare the following items:
 One Windows-based computer with print server setup CD
 One printer
 One printer cable
Hardware Installation
To install the print servers, you need to complete these steps:
․Confirm that your printer parallel port or USB Port works well.
․Connect the print server to the network and printer, and plug in the print server.
Follow these instructions to install the print servers, please refer to any peripheral
you are connecting to the print server:
1. Turn off the printer’s power.
2. Connect the print server to your printer with printer cable.
3. Turn the printer’s power on.
4. Plug the AC power adapter into the power connector on the print server.
5. Wait 10 seconds until all the LEDs have stopped flashing.
Note: The Status LED should be flash five times when POST. If not, please contact your
local dealer for repair or replacement.