User manual

208
Only the first occurrence of the attribute in the packet will be considered, and to be valid, it
must follow this rule:
• All 8 octets in the attribute's value must be identical and consist of ASCII characters in
the range '0' - '3', which translates into the desired QoS Class in the range [0; 3].
 RADIUS-Assigned VLAN Enabled :
When RADIUS-Assigned VLAN is both globally enabled and enabled (checked) for a given
port, the switch reacts to VLAN ID information carried in the RADIUS Access-Accept
packet transmitted by the RADIUS server when a supplicant is successfully authenticated.
If present and valid, the port's Port VLAN ID will be changed to this VLAN ID, the port will
be set to be a member of that VLAN ID, and the port will be forced into VLAN unaware
mode. Once assigned, all traffic arriving on the port will be classified and switched on the
RADIUS-assigned VLAN ID.
If (re-)authentication fails or the RADIUS Access-Accept packet no longer carries a VLAN
ID or it's invalid, or the supplicant is otherwise no longer present on the port, the port's
VLAN ID is immediately reverted to the original VLAN ID (which may be changed by the
administrator in the meanwhile without affecting the RADIUS-assigned).
This option is only available for single-client modes, i.e.
• Port-based 802.1X
• Single 802.1X
For trouble-shooting VLAN assignments, use the "Monitor→VLANs→VLAN Membership
and VLAN Port" pages. These pages show which modules have (temporarily) overridden
the current Port VLAN configuration.
RADIUS attributes used in identifying a VLAN ID:
RFC2868 and RFC3580 form the basis for the attributes used in identifying a VLAN ID in
an Access-Accept packet. The following criteria are used:
• The Tunnel-Medium-Type, Tunnel-Type, and Tunnel-Private-Group-ID attributes must all
be present at least once in the Access-Accept packet.
• The switch looks for the first set of these attributes that have the same Tag value and
fulfil the following requirements (if Tag == 0 is used, the Tunnel-Private-Group-ID does not
need to include a Tag):
- Value of Tunnel-Medium-Type must be set to "IEEE-802" (ordinal 6).
- Value of Tunnel-Type must be set to "VLAN" (ordinal 13).
- Value of Tunnel-Private-Group-ID must be a string of ASCII chars in the range '0' - '9',
which is interpreted as a decimal string representing the VLAN ID. Leading '0's are
discarded. The final value must be in the range [1; 4095].
 Guest VLAN Enabled :
When Guest VLAN is both globally enabled and enabled (checked) for a given port, the
switch considers moving the port into the Guest VLAN according to the rules outlined
below.
This option is only available for EAPOL-based modes, i.e.:
• Port-based 802.1X
• Single 802.1X
• Multi 802.1X
For trouble-shooting VLAN assignments, use the "Monitor→VLANs→VLAN Membership
and VLAN Port" pages. These pages show which modules have (temporarily) overridden
the current Port VLAN configuration.
Guest VLAN Operation:
When a Guest VLAN enabled port's link comes up, the switch starts transmitting EAPOL
Request Identity frames. If the number of transmissions of such frames exceeds Max.
Reauth. Count and no EAPOL frames have been received in the meanwhile, the switch
considers entering the Guest VLAN. The interval between transmission of EAPOL Request
Identity frames is configured with EAPOL Timeout. If Allow Guest VLAN if EAPOL Seen is