User manual

C HAPTER 4 | Configuring the Switch
Configuring Security
– 117 –
◆ MAC Address – Allowed source MAC address in ARP request packets.
◆ IP Address – Allowed source IP address in ARP request packets.
WEB INTERFACE
To configure the static ARP Inspection table:
1. Click Advanced Configuration, Network, Security, ARP Inspection, Static
Ta b l e .
2. Click “Add new entry.”
3. Enter the required bindings for a given port.
4. Click Save.
Figure 40: Configuring Static Bindings for ARP Inspection
SPECIFYING
AUTHENTICATION
SERVERS
Use the Authentication Server Configuration page to control management
access based on a list of user names and passwords configured on a
RADIUS or TACACS+ remote access authentication server, and to
authenticate client access for IEEE 802.1X port authentication (see
page 85)
N OTE : This guide assumes that RADIUS and TACACS+ servers have already
been configured to support AAA. The configuration of RADIUS and
TACACS+ server software is beyond the scope of this guide. Refer to the
documentation provided with the RADIUS and TACACS+ server software.
PATH
Advanced Configuration, Security, Network, AAA
PARAMETERS
These parameters are displayed:
Common Server Configuration
◆ Timeout – The time the switch waits for a reply from an authentication
server before it resends the request. (Range: 3-3600 seconds;
Default: 15 seconds)