User manual

C HAPTER 4 | Configuring the Switch
Multicast VLAN Registration
– 143 –
switch can only remove the interface from the multicast stream after
the host responds to a periodic request for a membership report.
Note that immediate leave should only be enabled on receiver ports to
which only one subscriber is attached. Otherwise, service to other
active receivers will be affected.
WEB INTERFACE
To configure global and interface settings for MVR:
1. Click Advanced Configuration, MVR.
2. Enable MVR globally on the switch
3. Click “Add New MVR VLAN,” enter MVR VLAN ID, set the operating
mode to control whether or not membership reports are sent from
source ports, specify whether or not control frames are tagged with the
MVR ID, set the priority and last member query interval.
4. Optionally enable immediate leave on any receiver port to which only
one subscriber is attached.
5. Click Save.
Figure 54: Configuring General MVR Settings
CONFIGURING MVR
CHANNEL SETTINGS
Use the MVR Channel Configuration page to view dynamic multicast group
bindings for a multicast VLAN, or to configure static bindings for a multicast
VLAN.
PATH
C
OMMAND USAGE
◆ Use the Navigate Channel Setting fields to specify the MVR VLAN and
number of entries to display per page. Then use the arrow keys to scroll
through the list of associated channels.
Advanced Configuration, MVR ( MVR Channel Configuration)