User manual

C HAPTER 4 | Configuring the Switch
Power over Ethernet
– 167 –
WEB INTERFACE
To configure LLDP-MED TLVs:
1. Click Configuration, LLDP-MED.
2. Modify any of the timing parameters as required.
3. Set the fast start repeat count, descriptive information for the end-
point device, and policies applied to selected ports.
4. Click Save.
Figure 63: LLDP-MED Configuration
POWER OVER ETHERNET
Use the Power Over Ethernet Configuration page to set the maximum PoE
power provided to a port, the maximum power budget for the switch
(power available to all RJ-45 ports), the port PoE operating mode, power
allocation priority, and the maximum power allocated to each port. If the
power demand from devices connected to the switch exceeds the power
budget, the switch uses port power priority settings to limit the supplied
power.
COMMAND USAGE
◆ The switch can provide DC power to a wide range of connected devices,
eliminating the need for an additional power source and cutting down