User manual

C HAPTER 4 | Configuring the Switch
Quality of Service
– 198 –
CONFIGURING DSCP
TRANSLATION
Use the DSCP Translation page to configure DSCP translation for ingress
traffic or DSCP re-mapping for egress traffic.
PATH
Advanced Configuration, QoS, DSCP Translation
PARAMETERS
These parameters are displayed:
◆ DSCP – DSCP value. (Range: 0-63)
◆ Ingress Translate – Enables ingress translation of DSCP values based
on the specified classification method.
◆ Ingress Classify – Enable Classification at ingress side as defined in
the QoS Port DSCP Configuration table (see page 195).
◆ Egress Remap – Re-maps the selected DSCP value.
WEB INTERFACE
To configure DSCP translation or re-mapping:
1. Click Advanced Configuration, QoS, DSCP Translation.
2. Set the required ingress translation and egress re-mapping
parameters.
3. Click Save.
Figure 84: Configuring DSCP Translation and Re-mapping
. . .