User manual

C HAPTER 4 | Configuring the Switch
Quality of Service
– 206 –
WEB INTERFACE
To configure WRED:
1. Click Configuration, QoS, WRED.
2. Enable WRED on the priority queues as required.
3. Set the minimum threshold below which no packets are dropped.
4. Set the drop probabilities for DP levels 1 through 3 as a percentage.
5. Click Save.
Figure 88: WRED Configuration
CONFIGURING
CONGESTION
MANAGEMENT
Use the Congestion Management page to specify whether or not to forward
traffic when the destination port is congested. Note that congestion
Management does not apply to priority 6 and 7, which are always allowed
to be forwarded.
PATH
Configuration, QoS, Congestion Management
PARAMETERS
These parameters are displayed:
◆ Mode - Specifies whether to enable or disable congestion
management. (Default: Enabled)
WEB INTERFACE
To configure WRED:
1. Click Configuration, QoS, Congestion Management.
2. Enable or disable congestion management as required.
3. Click Save.