User manual

HAPTER

| Configuring the Switch

Configuring Remote Port Mirroring

– 208 –

■

Tx only - Frames transmitted from this port are mirrored to the

destination port.

◆ Destination - Traffic from all configured source ports is mirrored to

this port. (Default: Disabled)

WEB INTERFACE

To configure local port mirroring:

1. Click Basic/Advanced Configuration, Mirroring & RSPAN.

2. Set the Mode to Enabled, and the Type to Mirror.

3. Set the type of traffic to mirror on the Source ports to be monitored.

4. Select to the Destination port to which all mirrored traffic will be sent.

5. Click Save.

Figure 90: Mirror Configuration

CONFIGURING REMOTE PORT MIRRORING

Use the Mirroring & RSPAN Configuration page to mirror traffic from remote

switches for analysis at a destination port on the local switch. This feature,

also called Remote Switched Port Analyzer (RSPAN), carries traffic

generated on the specified source ports over a user-specified VLAN

dedicated to that RSPAN session in all participating switches. Monitored

traffic from one or more sources is copied onto the RSPAN VLAN through

IEEE 802.1Q trunk or hybrid ports that carry it to any RSPAN destination

port monitoring the RSPAN VLAN as shown in the figure below.