User manual

C HAPTER 5 | Monitoring the Switch
Showing MLD Snooping Information
– 264 –
PARAMETERS
These parameters are displayed:
◆ VLAN ID – VLAN identifier.
◆ Group – The IP address of a multicast group detected on this interface.
◆ Port – Port identifier.
◆ Mode – The filtering mode maintained per VLAN ID, port number, and
Group Address. It can be either Include or Exclude.
◆ Source Address – IP Address of the source. Currently, the system
limits the total number of IP source addresses for filtering to be 128.
Different source addresses belong to the same group are treated as
single entry.
◆ Type – Indicates the Type. It can be either Allow or Deny.
◆ Hardware Filter/Switch – Indicates whether the data plane destined
to the specific group address from the source IPv4 address can be
handled by the chip or not.
WEB INTERFACE
To display IGMP Source-Filtered Multicast information, click Monitor, IGMP
Snooping, IGMP SFM Information.
Figure 135: IPv4 SFM Information
SHOWING MLD SNOOPING INFORMATION
Use the MLD Snooping pages to display MLD snooping statistics, port
members of each service group, and information on source-specific groups.
SHOWING MLD
S
NOOPING STATUS
Use the IGMP Snooping Status page to display MLD querier status and
snooping statistics for each VLAN carrying multicast traffic, and the ports
connected to an upstream multicast router/switch.
PATH
Monitor, IPMC, MLD Snooping, Status