User manual

C HAPTER 5 | Monitoring the Switch
Displaying LLDP Information
– 267 –
◆ Type – Indicates the Type. It can be either Allow or Deny.
◆ Hardware Filter/Switch – Indicates whether the data plane destined
to the specific group address from the source IPv4 address can be
handled by the chip or not.
WEB INTERFACE
To display MLD Source-Filtered Multicast information, click Monitor, MLD
Snooping, IPv6 SFM Information.
Figure 138: IPv6 SFM Information
DISPLAYING LLDP INFORMATION
Use the monitor pages for LLDP to display information advertised by LLDP
neighbors and statistics on LLDP control frames.
DISPLAYING LLDP
NEIGHBOR
INFORMATION
Use the LLDP Neighbor Information page to display information about
devices connected directly to the switch’s ports which are advertising
information through LLDP.
PATH
Monitor, LLDP, Neighbors
PARAMETERS
These parameters are displayed:
◆ Local Port – The local port to which a remote LLDP-capable device is
attached.
◆ Chassis ID – An octet string indicating the specific identifier for the
particular chassis in this system.
◆ Remote Port ID – A string that contains the specific identifier for the
port from which this LLDPDU was transmitted.
◆ System Name – A string that indicates the system’s assigned name.
◆ Port Description – A string that indicates the port’s description. If RFC
2863 is implemented, the ifDescr object should be used for this field.
◆ System Capabilities – The capabilities that define the primary
function(s) of the system as shown in the following table: