User manual

C HAPTER 5 | Monitoring the Switch
Displaying LLDP Information
– 268 –
When a capability is enabled, the capability is followed by (+). If the
capability is disabled, the capability is followed by (-).
◆ Management Address – The IPv4 address of the remote device. If no
management address is available, the address should be the MAC
address for the CPU or for the port sending this advertisement.
If the neighbor device allows management access, clicking on an entry
in this field will re-direct the web browser to the neighbor’s
management interface.
WEB INTERFACE
To display information about LLDP neighbors, click Monitor, LLDP,
Neighbors.
Figure 139: LLDP Neighbor Information
DISPLAYING
LLDP-MED
N
EIGHBOR
INFORMATION
Use the LLDP-MED Neighbor Information page to display information about
a remote device connected to a port on this switch which is advertising
LLDP-MED TLVs, including network connectivity device, endpoint device,
capabilities, application type, and policy.
PATH
Monitor, LLDP, LLDP-MED Neighbors
PARAMETERS
These parameters are displayed:
◆ Port - The port on which an LLDP frame was received.
Table 13: System Capabilities
ID Basis Reference
Other –
Repeater IETF RFC 2108
Bridge IETF RFC 2674
WLAN Access Point IEEE 802.11 MIB
Router IETF RFC 1812
Telephone IETF RFC 2011
DOCSIS cable
device
IETF RFC 2669 and IETF RFC 2670
Station only IETF RFC 2011