IEC-4000 Industrial Fast Ethernet mini Media Converter 10/100Mbps RJ-45 Copper to 100Mbps SFP Fibre Quick Installation Guide v1.
Overview LevelOne IEC-4000 is an industrial Fast Ethernet media converter with a rugged aluminium case which providing superb heat dissipation. This converter is designed to be mounted on an industrial standard DIN-rail, plus the clearly visible status LEDs provide simple monitoring of port link activity. It also features Link Fault Pass Through in order to alert remote location when link status changes.
Features 10/100BaseT to 100Base-FX Rugged aluminium case design in a ultra-compact form factor 18V-36VAC & 12V-60VDC with polarity protection Link Fault Pass through (LFP) function Supports switch and pure converter mode Surge & ESD protection Maximum noise & interference immunity -40°C to 75°C (-40°F to 167°F) operating temperature range DIN-Rail or panel mount installation Package Contents Industrial mini Media Converter Quick Installation Guide DIN-rail & Panel mount kits IEC-40
LED Status LED Status Description Steady Power On Off Power Off Steady Fibre link established Flashing Transmitting or Receiving data PWR LK/Act 10/100Base-TX Steady Network connection established Flashing Transmitting or Receiving data Steady 100M speed is established Off 10M speed is established Green Amber IEC-4000 Page 3
Terminal Block Power Input V+ V– 18 – 36VAC 12 – 60VDC Neutral Ground Earth Ground Note: This unit provides 3 pin terminal-block. And it can be operated using either VAC or VDC power source. The VDC power range is from 12VDC to 60VDC, and the VAC power range is from 18VAC to 36VAC. Always Make sure your input voltage is within this supported voltage range. WARNING – any exceeded input voltage will not make this unit function and may damage this unit.
DIP Switch ON OFF DIP2 DIP1 LFP enabled Converter Mode LFP disabled Switch Mode (default) (default) Note: This unit is equipped with dip switches, located on the front panel marked as SW1. Adjusting the dip switches will change the default function of this unit. This unit has set to manufacturer default as: switch mode and LFP function off. The table shown as you may change the dip switch setting to your desired environment.
DIN Rail Mount Assembly: Place the switch on the DIN rail from above using the slot.
SFP Transceiver (Optional) The IEC-4000 SFP slot supports pluggable modules (100BaseX only) that enabling you to choose from a variety of transceivers Comm ercial Industrial Model No.
SFP-1411 IEC-4000 155M SMF SFP Transceiver (40km, 1310nm, 0 to 70C) Page 8