Installation guide

IES-0822
Power Input
Terminal Block
PW1
PW2
Earth Ground
Relay Output
1.
The relay contact closes if Power1 and Power2 are both failed but Power3
on.
2.
The relay contact closes if Power3 is failed but Power1 and Power2 are both
on.
PW3: 48VDC
DC Jack
Power Input
+
48VDC
–
Power Ground
+
48VDC
–
Power Ground
Earth Ground
Relay Output
The relay contact closes if Power1 and Power2 are both failed but Power3
The relay contact closes if Power3 is failed but Power1 and Power2 are both
DC Jack
Input
Page 4
The relay contact closes if Power1 and Power2 are both failed but Power3
The relay contact closes if Power3 is failed but Power1 and Power2 are both
IES-0822
DIN Rail Mount
•
Assembly: Place the switch on the
the slot. Push the front of the switch toward the mounting
surface until it audibly snaps into place
• Start-
up: Connect the supply voltage to start up the switch
via the terminal block (or DC JACK)
•
Dismantling: Pull out the lower
switch from the DIN rail.
DIN Rail Mount
Assembly: Place the switch on the
DIN rail from above using
the slot. Push the front of the switch toward the mounting
surface until it audibly snaps into place
up: Connect the supply voltage to start up the switch
via the terminal block (or DC JACK)
Dismantling: Pull out the lower
edge and then remove the
switch from the DIN rail.
Page 5
DIN rail from above using
the slot. Push the front of the switch toward the mounting
up: Connect the supply voltage to start up the switch
edge and then remove the
IES-0822
10/100Base
The following lists the
Pin
PoE
Port
1
Output Transmit Data +
2
Output Transmit Data
3
Input Receive Data +
4 NC
5 NC
6
Input Receive Data
7 NC
8 NC
10/100Base
-
TX Connector
The following lists the
pin-out of 10/100Base-
TX ports.
(1 to 4)
Standard Port (5)
Output Transmit Data +
Input Receive Data +
Output Transmit Data
- Input
Receive Data
Input Receive Data +
Output Transmit Data +
NC
NC
Input Receive Data
-
Output Transmit Data
NC
NC
Page 6
TX Connector
TX ports.
Standard Port (5)
Input Receive Data +
Receive Data
-
Output Transmit Data +
Output Transmit Data
-
IES-0822
100Base
-
WDM 100Base
Connection
-
FX Connection
The Tx
(transmit) port of device I
is connected to the Rx (receive)
port of device II, and the Rx
(receive) port of device I to the
Tx (transmit) port of device II.
WDM 100Base
-BX
Connection
Only one optical fiber is required
to transmit and receive dat
Page 7
FX Connection
(transmit) port of device I
is connected to the Rx (receive)
port of device II, and the Rx
(receive) port of device I to the
Tx (transmit) port of device II.
Only one optical fiber is required
to transmit and receive dat
a