LevelOne KVM-0211/KVM-0411 KVM-0212/KVM-0412 2/4-Port PS/2 KVM Switch User Manual Ver. 1.0.
Safety FCC This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. CE This equipment is in compliance with the requirements of the following regulations: EN 55 022: CLASS B RoHS This product is RoHS compliant.
Table of Contents 1. 2. INTRODUCTION................................................................................................................................................... 1 1.1 FEATURE OVERVIEW ......................................................................................................................................... 1 1.2 PACKAGE CONTENTS ........................................................................................................................................
1. Introduction LevelOne KVM-0211/KVM-0411/KVM-0212/KVM-0412 is 2/4-port Slim Desktop PS/2 KVM Switch with optional audio and microphone switching function in select models. The KVM switch allows users to access, control two (KVM-0211/0212) or four (KVM-0411/0412) PS/2-enabled computers from a single console. (Keyboard, Monitor, Mouse, and speaker set and microphone).
1.2 Package Contents KVM-0211/KVM-0411/KVM-0212/KVM-0412 KVM Cable Set CD Manual Quick Installation Guide Check to make sure that all of the components are present and in good condition. If anything is missing, or was damaged in shipping, please contact your dealer immediately. Read this manual thoroughly and follow the installation and operation procedures carefully to prevent any damage to the KVM switch or to any other devices on the installation.
2. Hardware Installation The default setting of the KVM-0211/KVM-0411/KVM-0212/KVM-0412 is appropriate for most systems. The KVM Switch is a Plug-and-Play device for installation. In fact, user does not need to configure the KVM Switch before installation. For the first time installation of the KVM Switch, please follow the instructions below for setup sequence: 1. Connect the shared keyboard, monitor and mouse (and optional speaker set and 2.
4. Power up the connected computers one by one. After your computers are powered up, the keyboard and mouse will be recognized and now you can begin operating the KVM switch. 2.2 Easy Operation There are two methods to control the KVM Switch for PC switching: using the Face-Panel Push Buttons or Hotkey Commands. For audio/MIC switching, use the hotkey command. Face-Panel Buttons The Face-Panel Buttons allow a direct control over PC port switching; simply press the button to switch PC port.
* User-definable = SCROLL LOCK, CAPS, ESC, F12 or NUM LOCK Hotkey preceding sequence configuration: For users who want to use a preceding sequence other than two consecutive Scroll Locks, there are convenient ways to configure it: 1. Hit Scroll Lock + Scroll Lock + H, then the KVM switch will be ready for new preceding sequence selection. Or Press and hold down the last front-panel button (Button 2 or Button 4) for over 8 seconds, and then release the button. 2.
3.
4. Technical Specification Model No. PC Port PC Port Connector (All Female Types) KVM-0211/0212 KVM-0411/0412 2 4 VGA HDDB 15pin-F (integrated with PS/2 interface) 1 x PS/2 Keyboard 6-pin Mini Din-F Local Console Port (All Female Types) 1 x PS/2 Mouse 6 pin Mini Din-F 1x HDB 15-pin-F 1 x 3.
