LevelOne User Manual VDS-0110 / VDS-0111 Ethernet over VDSL2 Converter (Sender) Ethernet over VDSL2 Converter (Receiver) V1.
FCC Certifications This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Table of Content 1. INTRODUCTIONS ................................................................................... 4 2. APPLICATION NOTES ........................................................................... 4 3. FEATURES ............................................................................................. 5 4. PACKING CONTENTS ............................................................................ 5 5. LED INDICATORS ....................................................................
1. Introductions The VDS-0110 and VDS-0111, a line power pair of VDSL2 (Very high-bit-rate Digital Subscriber Line) converter, provides a broadband transmission up to 100/60Mbps of downstream/upstream data rate over single pair copper line for point-to-point Ethernet connectivity. With 100/60Mbps data rate, VDS-0110/VDS-0111 supports transmission distance up to 350 meters for line power connection.
3. Features ITU-T G.993.1, G.993.
5.
6. Dip Switches Settings Pin 1: Pin 1 Pin 2 Pin 3 Pin 4 VTU-C/R Mode Rate Limit SNR OFF VTU-C Interleaved 50/20 Mbps 9dB ON VTU-R Fast Full Rate 6dB VTU-C/R Switch VTU-C: The VDS-0110 converter will act as at the Central Office (CO) side. VTU-R: The VDS-0111 converter will act as at the Customer Premise Equipment (CPE) or Remote side. Pin 2: Mode for impulse noise protection Interleave mode: Protection for up to 250ms impulse noises with latency less than 6 ms.
Pin 3: Rate limit control 50/20 Mbps: Line rate limited to 50/20 Mbps. Full Rate: Provides up to 100Mbps/60Mbps line rate in short line. Pin 4: Signal to Noise Ratio (SNR) 9dB: Higher SNR margin (9dB) will result in less error with more stable VDSL2 link. 6dB: Original and Normal channel noise protection with 6 dB SNR.
7.
8. Technical Support Thank you for selecting LevelOne products. LeveOne’s website contains the latest user documentation and soft-ware updates for LevelOne products. Please contact LevelOne Technical Support through our website. World Wide Web http://www.level1.