User manual

13
2.2.4. WHG-505 Hardware
1
LED Indicators
There are three kinds of LED,
Power
,
Status
and
Hard-disk
, to indicate
different status of the system.
2
LCD Display
Allows network administrator to check important system settings such as
network interface, SZ configurations, etc. The navigations buttons from left to
right respectively are “Esc”, “Up”, “Down”, and “Enter”.
3
Console
The system can be configured via a serial console port. The administrator can
use a terminal emulation program such as Microsoft’s Hyper Terminal to login to
the configuration console interface to change admin password or monitor
system status, etc.
4
Reset
Press and hold the Reset button for about 5 seconds and status of LED on front
panel will start to blink before restarting the system.
Press and hold the Reset button for more than 10 seconds and status of LED
on the front panel will start to speed up blinking before resetting the system to
default configuration.
5
USB
Reserved for future use.
6
Mgmt
For management use only, it always will open WMI (Web Management
Interface) homepage.
7
WAN1/ WAN2
Two Gigabit WAN ports (10/100/1000 Base-T RJ-45) for uplink connections to
the external network, such as the ADSL Router from your ISP (Internet Service
Provider).
8
LAN1/ LAN2
Two Gigabit LAN ports for servicing LAN traffic (10/100/1000 Base-T RJ-45).
1
Power Supply Socket
Connecting the power cord to the built-in open-frame power supply (Input:
100~240 VAC, 50/60 Hz).
2
Power Switch
Power-On (

) & Power-Off ( O ).
3
Device Cooling Fan
Don’t block the cooling fans. Leave enough open space for ventilation.
1
2
3
4
5
6
7
8