Installation Manual

Series
Series 1000 and Series 2000 Installation Manual
Leviton Manufacturing Co., Inc. 14
Figure 4: Mounting the Enclosure
3.6 Installation of Voltage Lines
1. Connect 18 AWG min., 600 V min. insulated wiring for Line voltages and
Neutral to the appropriate locations in the breaker panel, in accordance with all
national and local electrical codes.
2. Route wires through the conduit if not already done.
3. Trim the wire to the appropriate length to avoid coils of excess wiring.
4. Strip wiring to approximately .300 inches if needed and connect to the
appropriate terminals. Wires should be tightened so that they are held snuggly in
place, but do not to over-tighten, as this may compress and weaken the conductor.