Instructions / Assembly

RECESSED DOOR/WINDOW TRANSMITTER

Cat. No. 56A00-1

Installation Instructions

DI-022-HL561-05AAR2253

(56I00-1)

WARNINGS AND CAUTIONS

• Read and understand all instructions. Follow all warnings and instructions marked on the

product.

• Do not use this product near water - e.g., near a tub, wash basin, kitchen sink or laundry

tub, in a wet basement, or near a swimming pool.

• Never push objects of any kind into this product through openings, as they may touch

dangerous voltages.

• Never install communications wiring or components during a lightning storm.

• Never install communications components in wet locations unless the components are

designed specically for use in wet locations.

• Never touch uninsulated wires or terminals unless the wiring has been disconnected at the

network interface.

• Use caution when installing or modifying communications wiring or components.

• SAVE THESE INSTRUCTIONS.

The 56A00-1 Recessed Door/Window Transmitter is a supervised

wireless contact that can be concealed with a door or window frame

for virtual transparency. It works with the Leviton 45A00-1 Wireless

Receiver and is supplied with a replaceable lithium battery that lasts

for 5 years under normal operation.

OPENING THE 56A00-1

Use a athead screw driver to open the 56A00-1 to change tops or

access the battery (See gure 1).

INSTALL BATTERY

Use care when installing the battery and observe the correct polarity when the

battery is inserted (See Figure 2). Use only Panasonic Lithium CR2 batteries

for replacement. When replacing battery use a athead screw driver to open

the top (See Opening the 56A00-1).

WARNING! Battery may explode if mistreated. Do not recharge,

disassemble or dispose of in ﬁre.

MOUNT TRANSMITTER AND MAGNET

It is important to select the proper placement of the recessed transmitter and

magnet. The transmitter has two separate tops that allow a ush mount or

screw mount in case you accidentally over drill the hole or require extra support to ensure the

transmitter does not move. The magnet does not have a second top with a ange to screw it

into place so you must be extra careful to ensure that the magnet is tightly in place

once installed.

WEB VERSION

PAGE 1
DI-022-HL561-05AAR2253 (56I00-1) RECESSED DOOR/WINDOW TRANSMITTER Cat. No. 56A00-1 Installation Instructions WARNINGS AND CAUTIONS • Read and understand all instructions. Follow all warnings and instructions marked on the product. • Do not use this product near water - e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. • Never push objects of any kind into this product through openings, as they may touch dangerous voltages.
PAGE 2
Step 1: Install the CR2 battery if you have not already done so (See Install Battery). Step 2: Write down the serial number printed on the outside of the 56A00-1 case or on the board inside where you place the battery. Step 3: Select a location on the door or window frame for the 56A00-1 transmitter and magnet to be installed. Use a marker or piece of clay to mark and ensure that the two holes that you intend to drill are lined up directly across from each other.