Cut Sheet

Installation Instructions
QuickPlate Wallplates
DI-XXX-5EA20-02A
QuickPlate Wallplates
DESCRIPTION
The QuickPlate Wallplates feature a variety of
combinations of both phone and data ports. The
wallplates also feature 110 IDC connectors for quick
and precise connection.
INSTALLATION
CAUTION: Read all important safety information
prior to installation.
Phone/data port connections:
Remove dust caps from back of connectors•
Strip approximately 2 inches of insulation from •
the main cable. Do not remove insulation from
individual wires.
Connect each conductor following the color codes •
on each connector and Figure 2 as follows:
Route the wires for termination•
Terminate one pair at a time starting with the blue •
pair of conductors. Note: terminating one pair at
a time will prevent damage to the other wires with
the punchdown tool.
Using the included plastic punchdown tool or a 110 •
punchdown tool (Leviton Cat No. 49553-814 and
49553-110), terminate the wires into the IDC slots.
Maintain wire pair twisting to within 1/2 inch of the
IDC connector.
Trim excess wire to within the connector body •
using punchdown tool cutting blade or wire cutters.
Place the dust cap over the terminated wires •
to secure the connections and provide added
strain relief.
Connect any coaxial cables to F-connectors, •
if applicable.
Mount the QuickPlate wallplate ensuring the word •
“UP” on the back is oriented properly. Secure
using screws provided.
Do Not over-tighten screws.
Installation is complete.•
5EA20-1 5EA20-2
5EA20-3 5EA20-4
2 Port
Cat No. 5EA20-2
1 Port
Cat No. 5EA20-1
3 Port
Cat No. 5EA20-3
4 Port
Cat No. 5EA20-4
For Technical Assistance Call:
1-800-824-3005 (U.S.A. Only)
www.leviton.com
Figure 1
UP
Mounting
Screw
Mounting
Screw
Orientation
Guide
Phone/Data
Port
Dust Cap
Quickplate
Wallplate