Instructions / Assembly
For Technical Assistance Call: 800-824-3005 - www.leviton.com
DI-021-95A04-05AAR2243© 2013 Leviton Mfg. Co., Inc.
FOR CANADA ONLY
For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton
Manufacturing of Canada Ltd to the attention of the Quality Assurance Department, 165 Hymus Blvd,
Pointe-Claire (Quebec), Canada H9R 1E9 or by telephone at 1 800 405-5320.
FCC Compliance
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SETTING THE FREQUENCY OF THE IR OUTPUT
When using the RIM to send IR data to source equipment, there are two
different IR carrier frequencies in which the RIM can transmit the IR signal.
The default setting of 38 kHz is used for most audio sources. However,
most cable and satellite converter boxes operate at a higher IR carrier
frequency closer to 56 kHz. Each RIM has a switch that allows you to
change the frequency of the IR output when using such devices.
To change the frequency setting, remove the faceplate and insert from the
RIM as described under “Changing the Color of the RIM”.
Once the insert has been removed, move the frequency switch (SW1) from
the “38kHz” position to the “56kHz” position.
38kHz 56kHz
TOP
Frequency
Switch
SW1
IR OUTPUT
Each RIM ships with an IR asher (62A08-1). The IR asher is used for
sending IR data to the source equipment. When you point your source
equipment remote control at the IR receiver in the VSC and send a
signal, the IR data is routed to the appropriate RIM
(to which the source is connected), which then sends the IR signal
through the IR asher to the source equipment.
LEVITON LIMITED WARRANTY
Leviton warrants to the original consumer purchaser and not for the benet of anyone else that products manufactured by
Leviton under the Leviton brand name (“Product”) will be free from defects in material and workmanship for the time periods
indicated below, whichever is shorter: • OmniPro II and Lumina Pro: three (3) years from installation or 42 months from
manufacture date. • OmniLT, Omni IIe, and Lumina: two (2) years from installation or 30 months from manufacture date. •
Thermostats, Accessories: two (2) years from installation or 30 months from manufacture date. • Batteries: Rechargeable
batteries in products are warranted for ninety (90) days from date of purchase. Note: Primary (non-rechargeable) batteries
shipped in products are not warranted. Products with Windows
®
Operating Systems: During the warranty period, Leviton
will restore corrupted operating systems to factory default at no charge, provided that the product has been used as
originally intended. Installation of non-Leviton software or modication of the operating system voids this warranty. Leviton’s
obligation under this Limited Warranty is limited to the repair or replacement, at Leviton’s option, of Product that fails due
to defect in material or workmanship. Leviton reserves the right to replace product under this Limited Warranty with new
or remanufactured product. Leviton will not be responsible for labor costs of removal or reinstallation of Product.
The repaired or replaced product is then warranted under the terms of this Limited Warranty for the remainder of the
Limited Warranty time period or ninety (90) days, whichever is longer. This Limited Warranty does not cover PC-based
software products. Leviton is not responsible for conditions or applications beyond Leviton’s control. Leviton is not
responsible for issues related to improper installation, including failure to follow written Installation and operation
instructions, normal wear and tear, catastrophe, fault or negligence of the user or other problems external
to the Product. To view complete warranty and instructions for returning product, please visit us at www.leviton.com.
Use herein of third party trademarks, service marks, trade names, brand names and/or product names are for informational
purposes only, are/may be the trademarks of their respective owners; such use is not meant to imply afliation, sponsorship,
or endorsement.
WEB VERSION