Hi-FiTM 2 Expansion Kit WEB VERSION Installation Manual © 2015 Leviton Mfg. Co., Inc.
WEB VERSION
WARNINGS AND CAUTIONS TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER at circuit breaker or fuse and test that power is off before wiring! If you are unsure about any part of these instructions, consult an electrician. To be installed and/or used in accordance with appropriate electrical codes and regulations. Use this device with copper or copper-clad wire only. For indoor use only. SAVE THESE INSTRUCTIONS.
TABLE OF CONTENTS INTRODUCTION..........................................................................................................................................................................................02 Features.............................................................................................................................................................................................02 Includes........................ ............................................................
Introduction This kit expands the Leviton Hi-FiTM 2 Whole Home Audio Distribution System from an 8 Audio Zone system to a 16 Audio Zone system.
Connecting the Expansion Assembly to the Hi-FiTM 2 Main Assembly To connect the Expander, insert the supplied ribbon cable into the Expander connector under the section labeled “To Expander” on the Hi-Fi 2 Main Assembly. Connect the other end of the ribbon cable to the connector on the Hi-Fi 2 Expansion Assembly under the section labeled “To Main”. Installing Volume-Source Control (VSC) Keypads The audio sources can be selected and controlled by any Volume-Source Control (VSC).
Terminating Speaker Wires Always observe proper orientation of the positive and negative signal for each speaker connection. Typically, when using two-conductor speaker wire, the red wire indicates positive (+) and black wire indicates negative (-). Another indication of positive is a dark line running through the insulation. Four-conductor wire can also be used and makes for a neater installation.
SPECIFICATIONS Zones 1-8 Power Amplifier Outputs Continuous Average Output Power: Rated Distortion (1/2 power): Rated Impedance: Damping Factor: Frequency Response (20-20kHz): 50W (25W x 2) Two channels driven 20-20kHz @1% THD 0.
WEB VERSION
WEB VERSION
WEB VERSION
FCC COMPLIANCE FOR CANADA ONLY WEB VERSION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.