Instructions / Assembly

Key Card Switch
Cat. No. HKSWP-0LX
INSTALLATION
English
WARNINGS AND CAUTIONS:
• DISCONNECT POWER AT CIRCUIT BREAKER OR FUSE WHEN SERVICING, INSTALLING OR REMOVING FIXTURE.
• TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH ELECTRICAL CODES AND REGULATIONS.
• IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT AN ELECTRICIAN.
DESCRIPTION:
These Key Card Switches are low voltage devices which switch power ON and OFF according to whether a key card (similar to those used in hotels) is
inserted in the card slot on the device. The devices are wired to either a building control system or a Leviton Power Pack. When a key card is inserted in the
slot, an optical beam is interrupted by the card, signaling the circuitry to switch the relay ON. When the card is removed, the optical beam is restored, and a
countdown timer is initiated. After approximately 30 seconds, the timer expires and the relay is switched OFF. This delay ensures that a user can safely exit a
room prior to the lights turning OFF.
To assist in locating the switch when the user enters a dark room, the card
slot is illuminated by low energy LEDs. When a card is inserted in the slot,
the LEDs are switched OFF
INSTALLATION:
1. Make sure power has been turned OFF at the circuit breaker.
2. Remove the pre-stripped insulation from the wires to expose the copper
wire.
3. Using a Leviton Power Pack or the Building Control System wiring,
connect the devices following the wiring diagrams provided:
• Connect the RLY COMM to the wire terminal
• Connect the N.O. wire to the wire terminal (used for Power Packs or
when normally open relay is desired)
• Connect the N.C. wire to the wire terminal (used for BAS or when
normally closed relay is desired)
• Connect the red 24V power wire to either AC/DC wire terminal
• Connect the black COMM wire to either AC/DC wire terminal
• Connect one blue LOAD wire to the load switches and outlets to be
controlled in the room.
• Connect the white NEUTRAL wire from the building wiring to the
white wire on the power pack.
• Connect the black HOT/LINE wire from the building wiring to one
black and one blue wire on the power pack
4. Install the device in the wall box and secure it to the wall box with the
screws provided.
5. Attach the cover plate.
6. Restore power to the circuit.
Low Voltage Relay Rating:
• Input Voltage: 24VDC/24VAC
• Output: Form C (1 Normally Open, 1 Normally Closed ) rated at
1A/30VDC
• Standby Power Consumption: 0.66W AC or 0.24W DC max
Power-Up Time/ Warm-Up time:
• 0LX = up to 5 seconds max
Environmental:
• Ambient operating temperature: 32 -131 °F (0-55°C)
• Maximum 95% non-condensing relative humidity
• Storage Temperature: -32 to 158°F (0 to 70°C)
• Indoor use only
Terminal blocks
• AC/DC Inputs: (+) 24V, (-) COM
• AC/DC Outputs : NO – Normally Open, NC – Normally Closed, COM
• Will accommodate single conductor #18 - #26 AWG
• Torque terminals to 4in lbs.
The Card Key switch assembly slot accepts standard size card keys – 3.375 " W x 2 .125" H, .034” thick.
OPERATION:
When power is applied to these devices, they are immediately ready for operation according to the card status. If the card is inserted, the relay will turn ON. If the
card is not present, the relay will remain OFF. Once the relay is ON and the card is removed, there is a 30 second time-out delay before the relay turns OFF.
Leviton is a registered trademark of Leviton Mfg. Co. in the United States, Canada, Mexico, and other countries. Other trademarks herein are the property of their respective owners.
Power Pack Wiring / Raccordement à un bloc d’alimentation / Cableado del Bloque de Alimentación
RLY COMM
RLY COMM
Relevador Comercial
HKSWP-0LX
N.O.
Power Pack
Bloc d’alimentation
Carga de iluminación
24V AC/DC / 24 V c.a./c.c.
Black Hot/Line
NoirActif/ligne
Negro Fase//Línea
Blue (Load)
Bleu (Charge)
Azul (Carga)
Blue (Load)
Bleu (Charge)
Azul (Carga)
2
2
2
1
1
1
3
3
3
Lighting Load /
Charge d’éclairage
Carga de iluminación
2
1
Local Switches / Interrupteurs locaux
Interruptores Locales
3
Controlled receptacles inside the room
Prises commandées dans la pièce
Controla receptáculos dentro de la habitación
Neutral (White)
Neutre (Blanc)
Neutro (Blanco)
Neutral (White) / Neutre (Blanc)
Neutro (Blanco)
Building Control System Wiring / Raccordement à un système de commande d’immeuble
Cableados del sistema de control del edificio
RLY COMM / RLY COMM
Relevador Comercial
HKSWP-0LX
24V AC/DC / 24 V c.a./c.c.
N.O.
N.C. / N.F.
Lighting control panel or
other building control system
Panneau de commande
d’éclairage ou système
de commande d’immeuble
Panel de control de iluminación u
otro sistema del control del edificio
© 2010 Leviton Mfg. Co., Inc.
DI-040-HKSWP-22A
For Technical Assistance Call: 1-800-824-3005 (U.S.A. Only)
www.leviton.com
LIMITED 5 YEAR WARRANTY AND EXCLUSIONS
Leviton warrants to the original consumer purchaser and not for the benet of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and
proper use for ve years from the purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option, if within such ve year period the product is returned prepaid, with proof
of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality Assurance Department, 201 North Service Road, Melville, New York 11747. This warranty excludes
and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused, opened,
abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including
merchantability and tness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and tness for
a particular purpose, is limited to ve years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment,
lost sales or prots or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.