Installation Guide

1
4
2
5
3
6
Cat. No. E5325DI-000-E5325-02A
Installation Instructions
TAMPER-RESISTANT OUTLET
15A-125V
decora edge
™
SAFER, FASTER, and EASIER
Recommended Tools
Features
Preparing Wires
Lever Wiring Feature
Wiring Your Device
If you need help...
ONLINE
www.leviton.com/support
CHAT
www.leviton.com/contact
CALL
1-800-824-3005 (USA)
1-800-405-5320 (Canada)
Leviton Manufacturing Co., Inc.
201 North Service Road, Melville, NY 11747
© 2022 Leviton Manufacturing Co., Inc. All rights reserved.
Specifications subject to change at any time without notice.
Leviton’s Decora Edge
Tamper-Resistant Outlet
makes it safer, faster, and
easier to install a new outlet.
Colored levers easily identify
where to connect each wire.
There are no exposed wires or
metal parts after installation.
Built-in strip gauge.
An extra large plastic strap
facilitates installation in large
wall openings.
Designed for midway
wallplates for extra coverage,
or you can easily convert it to
use with standard wallplates
by removing the break-off tabs.
Built-in alignment feature
to align other Decora Edge
products in a multi-gang
installation. (See page 13.)
Terminates wire with a snap
The colored levers snap shut to terminate the wires.
Levers
Le
vers
Strip Gauge
Strap
Alignment Tab
and Notch
Aligns devices for
multi-
gang installations.
Split Circuit Cover
Covers the split
c
ircuit tab from live
wire access. Break
off for split circuits.
Break-off Fins
Break off to install a
standard
size wallplate.
The color-coded levers easily identify where to connect
the wallbox wires to the outlet.
NOTE: Wire colors in your wallbox may be different from
the lever colors. See “Preparing Wires,” on page 5 to
make sure you insert the wires properly
.
Line/
Lo
ad
Levers
Ground
Lever
Neutral
Levers
Slotted/Phillips Screwdriver
Needle Nose Pliers
Wire Stripper
Voltage Tester
(measure bare wire here)
Use Built-in
Strip Gauge on the Outlet
Use Strip Gauge
as shown below
1. M
ake sure that the ends of the
wires from the wallbox are straight
(cut if necessary).
2. S
trip each wire in the wallbox, as shown below.
OR
9/16 in.
(1.4 cm)
WARNING: TO AVOID FIRE, SHOCK, OR DEATH, TURN
OFF POWER at circuit breaker or fuse and test that power
is OFF before wiring!
1. Remove the existing outlet.
2. V
erify that you have a Line (Black) wire, Neutral
(White) wire, and a Ground (Bare Copper or
Green) wire.
NOTE: W
ork on only one connection at a time.
3. Fully open lever
.
5. Fully close lever.
4. Insert the proper wire per
lever color into the wire
hole. Make sure the wire
is fully inserted and no
bare wire is exposed.
6. To complete wiring, proceed to page 7 or 8.
NOTES:
•
Use with #12 AWG or #14 AWG solid or stranded wire only.
• DO NOT use copper clad wires with this device.
NOTE: If using stranded
wire twist wire
before insertion.
WEB VERSION