Installation Guide

Page 6

Maximum number of dimmers.

This parameter must be set to reﬂect a number greater than or equal to the maximum number

of dimmer channels installed in the system. The factory default is 32 dimmer channels. If this

number is correct then this step may be ignored.

The maximum number of dimmers may be set as follows:

1. Make sure that the 400CP is in the program select mode as discussed.

2. Press the zone 1 increase button and the BUSY led will quit ﬂashing.

3. Press button representing desired number of dimmers as shown in the diagram.

4. If more than 256 dimmers are required then press a second button so that the sum of the

values of the two buttons pressed will equal the desired number of dimmers.

5. The unit will exit this programming mode and the BUSY LED will start ﬂashing again on

release of the second press, or after a few seconds if only one press was required.

SCENE 1 SCENE 2 SCENE 3 SCENE 4

SCENE 5 SCENE 6 SCENE 7 SCENE 8

LUMA-NET

408 CP

PWR BUSY

DOWN UP ADD DELETE

SCENE 1 SCENE 2 SCENE 3 SCENE 4

LUMA-NET

404 CP

PWR BUSY

DOWN UP ADD DELETE

DIMMER ASSIGNMENT MODE

WEB VERSION