Installation Guide

Page 8
Scene fade time programming.
Each zone may be programmed with an individual fade time. This is the time it will take the
dimmer channels assigned to go from full off to full on and visa versa. Fade time can vary from
0 to 13 seconds. A longer fade time will increase the accuracy when using the increase and
decrease buttons to set desired lighting levels. A fade time of 0 seconds will cause instant full
on or full off operation whenever the increase or decrease buttons are pressed. If the factory
default setting of 5 seconds is desired for each zone then this step may be ignored.
To program zone fade time:
1. Make sure that the 400CP is in the program select mode as discussed.
2. Press the zone 3 increase button to enter "fade time mode" and the BUSY LED will stop
flashing.
3. Select the desired zone by pressing the associated button as shown in the diagram.
4. Press button marked with desired fade time in seconds.
5. Unit will exit this programming mode after the release of the button and the BUSY LED will
start flashing again.
ZONE 1 ZONE 2 ZONE 3 ZONE 4
PWR BUSY
LUMA-NET
INCREASE
MEMORY LIGHTING CONTROLLER
DECREASE
400 CP
FADE TIME MODE
0 1 3 5
7 9 11 13
WEB VERSION