Installation Guide

Page 9
Master/Slave Mode
400CP panels may be slaved to one another. Several panels may act as slaves to a master
panel which contains the programming. The slaves will mimic the master LED’s and will
operate the scenes and fade times of the master. This is ideal for installations with several
panels in one room.
To make a panel into a master (factory default); set the Master\Slave ID to 0. To make a panel
into a slave; set the Master/Slave ID to the Network ID of the desired master to slave to.
To set Master/Slave ID number:
1. Make sure that the 400CP is in the program mode as discussed.
2. Press the zone 4 increase button and the BUSY LED will stop flashing
3. Look up the necessary sequence of 1’s and 0’ for the ID number on the chart at the end of
this section.
4. Using the two buttons indicated below, enter the eight number sequence of 1’s and 0’s.
5. The unit
NOTE : All other programming (except network ID) will have no effect if unit is made
into a slave. The master unit will contain the programming for all units slaved to it.
Slave units must still have a unique Network ID number (see following section).
ZONE 1 ZONE 2 ZONE 3 ZONE 4
PWR BUSY
LUMA-NET
INCREASE
MEMORY LIGHTING CONTROLLER
DECREASE
400 CP
0 1
MASTER / SLAVE MODE
WEB VERSION