Use and Care Manual

Chapter 2 Operation
Page 8 N3004 / N3008 User Guide
Setting Channel Levels
Master Fader
The Master Fader is used to proportionally control the output of all the console channels. For example,
if the level of channel 1 is at 80% and the master is set at 50%, the actual output of channel 1 will be
40%. A Master Fader LED is located directly above the fader to give the user intensity feedback.
Master Bump Button
When pressed, the Master Bump button, located directly below the Master Fader, will bring all fader
levels being output to full intensity.
Channel Faders
Individual channel levels are adjusted directly with the channel faders. To give the user channel
intensity feedback, channel intensity LED’s are provided above the faders.
See the following example to use channel faders to set levels:
Procedure: Notes:
1. Press [SC/CH] until LED is Off
2. Raise the Master Fader to 100% (full)
3. Raise Faders [1] thru [4] to 100% (full)
4. Lower the Master to 50%. Channel levels are proportionally lowered
to 50 (50% of 100 = 50)
The [SC/CH] button LED must be Off to adjust individual channels.
Channel Bump Buttons
When the [SC/CH] LED is Off, the bump buttons located below each fader allow individual channels
to change instantly to full intensity.