Use and Care Manual

Rev. B
Page 9
Scenes
Depending on the model, up to 8 scenes may be recorded for playback. Once channel levels are
recorded, the scene can be recalled by either raising the scene’s fader or pressing the corresponding
bump button.
Recording Scenes
The following example shows how to record channels into a simple scene:
Procedure: Notes:
1. Press [SC/CH] until LED is Off
2. Raise Master Fader to 100% (full)
3. Raise Faders [1] thru [4] to 100% (full)
4. Press and Hold
[PROG] [PROG] LED turns On
5. Press Bump Button [1] [PROG] LED turns Off, Scene 1 is recorded
6. Release [PROG] and Bump Button [1]
Make sure to Press and Hold the [PROG] button while recording scenes.
Recalling Scenes
To recall the recorded scene in the example above, see the following:
Procedure: Notes:
1. Press [SC/CH] until LED is On
2. Raise Master Fader to 100% (full)
3. Raise Fader [1] to 100% (full) LED’s of Channels recorded in Scene 1 light
4. Lower Fader [1] to 0%
5. Press Bump Button [1] LED’s of Channels recorded in Scene 1 light
The [SC/CH] button LED must be On to recall scenes.
Scene Bump Buttons
When the [SC/CH] LED is On, the bump buttons located below each fader allow the recorded scene
to change quickly to full intensity.