Use and Care Manual

Chapter 2 Operation
Page 10 N3004 / N3008 User Guide
Chases
As mentioned earlier, a Chase is a series of factory programmed individual channel patterns or user
recorded scenes that can be played back in a continuous loop. The [SPEED] control adjusts the step
rate of the chase which is indicated by an LED that will flash whenever the chase is activated. The
direction of the chase can be reversed by pressing the [PROG] button. To black out the chase
sequence, press the [BLACK] button. The chase rate can also be triggered by an audio input as
explained further below in the
Audio Chase section.
Channel Chase
Channel Chase 1 is factory programmed to activate channels 1-4 as indicated in the figure below:
Channel Chase 2 is factory programmed to activate channels 5-8 as indicated in the figure below:
To initiate a channel chase, follow the example below:
Procedure: Notes:
1. Press [SC/CH] until LED is Off
2. Raise Master Fader to 100% (full)
3. Press [CHASE 1]
4. Adjust [SPEED] control to set rate LED’s 1-4 flash
5. Press [PROG] to reverse direction